
Quality & IP
What we check, and what we own
Buying capital equipment from overseas is an act of trust. These are the verifiable parts — registered patents, documented inspection stages, and a test run you can attend.
Four checks before a line leaves
These are the stages that catch the faults which are expensive to fix once a mill is on your floor.
Roll geometry inspection
Every roll set is measured against its drawing before it goes into a stand. Roll profile error is the single most common cause of out-of-round tube, and it is invisible until you run material.
Frame alignment
Stands are aligned as an assembled line, not individually. A mill aligned stand-by-stand on a bench will not necessarily be aligned once bolted to a base.
Electrical and safety test
Control cabinets are wired and tested to the destination voltage and frequency, with emergency stop circuits and guarding verified before shipment.
Full-output test run
The line runs to rated output on material matching your specification. We record the tube it produces, and you are welcome to be present.
10 registered utility-model patents
Granted by CNIPA, the China National Intellectual Property Administration. These cover mechanisms in our forming, welding and finishing equipment — the practical consequence for you is that the designs are ours to support and modify, not licensed in from elsewhere.
Awards and industry recognition
Inspection before you pay
We would rather you checked than took our word for it. Two things are available to any buyer, on any order:
- Third-party pre-shipment inspection. We accept inspection by SGS, Bureau Veritas, TÜV or an agency of your choosing. You appoint them, they inspect the line in our factory before it is crated, and they report to you — not to us.
- A test run you attend in person. Your line runs to rated output on material matching your specification, and you watch it. For a purchase of this size it is the cheapest insurance available.
Either is more informative than a certificate, because the result is specific to your machine rather than to our quality system in general.
Inspect before you pay
We welcome third-party pre-shipment inspection and buyer-witnessed test runs. Ask us how to arrange either.
Reply within one business dayEngineer, not a call centre












